Analog Devices EV-ADuCM340ARDZ

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the Analog Devices EV-ADuCM340ARDZ evaluation board.
AnalogDevices EV-ADuCM430ARDZ.jpg

Preparing for J-Link

  • Connect the J-Link via P11 to the target board
  • Power the board via P34 (5V center positive)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

AnalogDevices EV-ADuCM430ARDZ JLinkCommander Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-ADuCM430ARDZ.
It is a simple Hello World sample linked into the internal flash.