Analog EV-L850A1Z

This article describes specifics for the Analog Devices EV-L850A1Z evaluation board.

Minimum requirements

• J-Link software V7.61c or later

Preparing for J-Link

• Connect the J-Link debug connector.
• Power the board via 12V power supply
• The board should look like this:

• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-L850A1Z. It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.61c
• Embedded Studio: V5.66
• Hardware: Analog Devices EV-L850A1Z evalboard
• Link: File:Analog ADRF8850 TestProject ES V566.zip