Geehy APM32F103ZET6

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the Geehy (Previously known as APEXMIC) APM32F103ZET6 evaluation board. It can be used to test & verify APM32F103xx device support.


Minimum requirements

  • J-Link software V6.84 or later

Preparing for J-Link

  • Connect the J-Link to the JTAG header (J5)
  • Power the board via external power supply USB (J2)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:


Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Geehy APM32F103ZET6. It is a simple Hello World sample linked into the internal flash. SETUP