GigaDevice GD321x0T-START

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the GigaDevice GD321x0T-START evaluation board.
GigaDevice GD32F190T8 GD321x0T-START board.jpg

Preparing for J-Link

  • Connect the J-Link to this pins:
J-Link Pin Connector Pin Name
VTref JP1 20 +5V
GND JP1 19 GND
TMS/SWDIO JP2 6 PA13
TCK/SWCLK JP2 9 PA14
  • Power the board via CN100.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

GigaDevice GD32F190T8 GD321x0T-START connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD321x0T-START.
It is a simple Hello World sample linked into the internal flash.

SETUP