GigaDevice GD32A503-EVAL

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board.

GD GD32A503V-EVAL Board.jpg

Minimum requirements

  • J-Link software V7.82b or later

Preparing for J-Link

  • Connect the J-Link to the JTAG header (JP2)
  • Power the board via USB (GD-LINK CN100)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

GD GD32A503 EVAL GD32A503VD Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32A503-EVAL.
It is a simple Hello World sample linked into the internal flash.