Mindmotion-MB-032

From SEGGER Wiki
Jump to navigation Jump to search

This article describes specifics for the Mindmotion MB-032 evaluation board.

MM-MB-032-board.jpg

Minimum requirements

  • J-Link software V7.82e or later

Preparing for J-Link

  • Connect the J-Link : VTref= CN6-9 / GND=CN6-7 / SWDIO=CN9-8(18 on PCB) / SWDCLK=CN6-4
  • Power the board via USB (CN3)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MM MB-032 MM32F0010A1T Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-032 MM32F0010A1T.
It is a simple Hello World sample linked into the internal flash.

SETUP