Mindmotion-NANO-F0270

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the Mindmotion NANO-F0270 evaluation board.

MM-NANO-F0270-board.jpg

Minimum requirements

  • J-Link software V7.82e or later

Preparing for J-Link

  • Connect the J-Link to J4 (Pin 1 is not at the DOT on the PCB, rotate cable 180°)
  • Power the board via USB (UART or USB port)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MM NANAO-F0270 MM32F0270D7P Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion NANO-F0270 MM32F0273D7P.
It is a simple Hello World sample linked into the internal flash.

SETUP