NXP K32W041AM

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the NXP K32W041AM extension board installed on the OM15076-3/JN5189 carrier board.

K32W041AM extension board OM15076-3/JN5189 carrier board

Minimum requirements

  • J-Link software V7.23a or later

Preparing for J-Link

The OM15076-3/JN5189 carrier board features a standard 10-pin SWD debug connector.

  • Connect the K32W041AM extension board to the OM15076-3/JN5189 carrier board
  • Connect the J-Link to the 10-pin SWD debug connector
  • Power the board using the mini USB connector

The result should be looking like this:

NXP K32W041AM wired.jpg

  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP K32W041AM Connect.PNG

Example Application

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the K32W041AM. It is a simple Hello World sample linked into the internal flash.

SETUP: