NXP MIMXRT106A-ALEXA2

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the NXP MIMXRT106A-ALEXA2 IoT evaluation board.

TBD

Minimum requirements

  • J-Link software V6.83c or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (J6)
  • Power the board via USB C cable (CON1)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

TBD

Example Project

The application toggles the red LED on the NXP MIMXRT106A-ALEXA2 IoT evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone. SETUP