NXP i.MX RT685 SuperMonkey

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the NXP i.MX RT685 SuperMonkey evaluation board.

NXP SuperMonkey.jpeg

Minimum requirements

  • J-Link software V7.65b or later

Preparing for J-Link

  • Connect the J-Link to the debug connector (J3)
  • Power the board via USB

Afterwards, the board should look similar to this:
NXP SuperMonkey Wired.PNG


Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP SuperMonkey Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP i.MX RT685 SuperMonkey. It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=NXP_i.MX_RT685_SuperMonkey&oldid=11858"