SPC560D-Discovery Evalboard

From SEGGER Wiki
Jump to: navigation, search

The ST SPC560D-Discovery evaluation board needs to be setup manually before it can be debugged using an external J-link because by default, the on board debugger drives the debug pins. To isolate the on board debugger from the MCU, in order to make sure that it does not interact with the J-Link, the following solder bridges needs to be removed (see table / board image):

wiki-board-ST-SPC560D-DIS.png
SPC560D-Discovery
J101
J103
J105
J109
J110
J111
J114