STM32H7B3I-EVAL

This article describes specifics for the ST STM32H7B3I-EVAL evaluation board.

Preparing for J-Link

• Connect the J-Link to the 20-pin JTAG debug connector (CN14)
• Power the board via the 5V DC power jack (CN17)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ST STM32H7B3I-EVAL.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.86d
• Embedded Studio: V7.10
• Hardware: ST STM32H7B3I-EVAL
• Link: File:ST STM32H7B3I-EVAL TestProject ES V710.zip