Telink TLSR9518ADK80D

From SEGGER Wiki
Jump to: navigation, search
Telink TLSR9518ADK80D evaluation board (TLSR9518 series)

The Telink TLSR9518ADK80D is a Telink TLSR9518 evaluation board.

Features (selection)

  • RISC-V 32Bit MCU
  • 2MB on board QSPI flash
  • Micro USB-B 1.1
  • Line-In
  • On board LED
  • external debug connector pins

For further information please refer to the Telink TLSR9 wiki page

Setting up with J-Link

Telink TLSR9518 series debug interface connection front
Telink TLSR9518 series debug interface connection rear

The Telink TLSR9518ADK80D evaluation board comes with an external JTAG debug connector (6 pins: TDI, TDO, TCK, TMS, GND, VBUS). To set the board up with J-Link, the following steps are required:

  1. Connect the J-Link to the evaluation board, using jumper wires as follows at connector J56:
    Pin RP Pico Pin J-Link Signal
    "TL PE4 TDI" 5 TDI
    "TL PE5 TDO" 13 TDO
    "TL PE7 TCK" 9 TCK
    "TL PE6 TMS" 7 TMS
    "DEBUG" "GND" 4 GND
    "VBUS" 1 VTref

Note: For a more reliable, simpler solution, the SEGGER Flying Wire Adapter is recommended.

Example Projects