Tracing on Atmel ATSAMD51

From SEGGER Wiki
Jump to: navigation, search

This article describes how to get started with trace on the Atmel ATSAMD51 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The Atmel ATSAMD51 implements tracing via pins, so a J-Trace can be used for tracing.

Sample project

The ATSAMD51 MCU is in regards of tracing comparable to the ATSAME54 so the following example projects can be used as reference: https://wiki.segger.com/Tracing_on_Atmel_ATSAME54

Make sure to set the correct device in your Ozone project.