Tracing on TI TM4C129

From SEGGER - Support Wiki
Jump to: navigation, search

This article describes how to get started with trace on the TI TM4C129 MCU. This article assumes that there is already a basic knowledge about trace in general (what is trace, what different implementations of trace are there, etc.). If this is not the case, we recommend to read Trace chapter in the J-Link User Manual (UM08001). The TI TM4C129 MCU implements tracing via pins, so a J-Trace can be used for tracing.

Sample project

The TI TM4C129 MCU is comparable to the TI MSP432E4 so the following example project can be used as reference: https://wiki.segger.com/Tracing_on_TI_MSP432E4

Make sure to set the correct device in your Ozone project.