Difference between revisions of "Adjusting trace timings and general troubleshooting"
(Created page with "This article will explain how the trace sample timing of the J-Trace Pro can be adjusted and some general troubleshooting steps if a setup does not work out-of-the-box as it w...") |
(→Trace Timing Configuration) |
||
Line 4: | Line 4: | ||
== Trace Timing Configuration == |
== Trace Timing Configuration == |
||
+ | In some cases a target device or board design will output trace signals that do not follow the [[Arm_trace_technical_specification#Arm_trace_timing_requirements | Arm trace timing requirements]]. If the issue is due to an incorrect sampling point in the time domain this can be fixed with J-Trace Pro's "Trace Timing Configuration" feature. |
||
+ | |||
+ | === Configuration with Ozone === |
||
+ | |||
+ | === General configuration === |
||
== Common trace timings == |
== Common trace timings == |
Revision as of 15:59, 22 September 2022
This article will explain how the trace sample timing of the J-Trace Pro can be adjusted and some general troubleshooting steps if a setup does not work out-of-the-box as it would be typically expected.
Contents
Trace Timing Configuration
In some cases a target device or board design will output trace signals that do not follow the Arm trace timing requirements. If the issue is due to an incorrect sampling point in the time domain this can be fixed with J-Trace Pro's "Trace Timing Configuration" feature.