Adjusting trace timings and general troubleshooting

From SEGGER Wiki
Revision as of 16:59, 22 September 2022 by Nino (talk | contribs) (Trace Timing Configuration)
Jump to: navigation, search

This article will explain how the trace sample timing of the J-Trace Pro can be adjusted and some general troubleshooting steps if a setup does not work out-of-the-box as it would be typically expected.

Trace Timing Configuration

In some cases a target device or board design will output trace signals that do not follow the Arm trace timing requirements. If the issue is due to an incorrect sampling point in the time domain this can be fixed with J-Trace Pro's "Trace Timing Configuration" feature.

Configuration with Ozone

General configuration

Common trace timings

Trace signal quality

The good

The bad

The ugly

FAQ