Difference between revisions of "Analog EV-L850A1Z"

From SEGGER Wiki
Jump to: navigation, search
(Preparing for J-Link)
(Preparing for J-Link)
 
(No difference)

Latest revision as of 14:51, 13 January 2022

This article describes specifics for the Analog Devices EV-L850A1Z evaluation board.

Analog ADRF8850.jpg

Minimum requirements

  • J-Link software V7.61c or later

Preparing for J-Link

  • Connect the J-Link debug connector.
  • Power the board via 12V power supply
  • The board should look like this:

Analog ADRF8850 connected.jpg

  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Analog ADRF8850 Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-L850A1Z. It is a simple Hello World sample linked into the internal flash.

SETUP