Analog EV-L850A1Z

From SEGGER Wiki
Revision as of 14:48, 13 January 2022 by Matthias (talk | contribs) (Created page with "__TOC__ This article describes specifics for the Analog Devices EV-L850A1Z evaluation board. 450px == Minimum requirements == * J-Link softwar...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the Analog Devices EV-L850A1Z evaluation board.

Analog ADRF8850.jpg

Minimum requirements

  • J-Link software V7.61c or later

Preparing for J-Link

  • Connect the J-Link debug connector.
  • Power the board via usb power supply
  • The board should look like this:

Analog ADRF8850 connected.jpg

  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Analog ADRF8850 Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Analog Devices EV-L850A1Z. It is a simple Hello World sample linked into the internal flash.

SETUP