Difference between revisions of "CMSemicon BAT32G133-EVB"

From SEGGER Wiki
Jump to: navigation, search
(Preparing for J-Link)
(SETUP)
Line 64: Line 64:
 
*J-Link software: V7.82c
 
*J-Link software: V7.82c
 
*Embedded Studio: V6.40
 
*Embedded Studio: V6.40
*Hardware:
+
*Hardware: CMSemicon BAT32G133-EVB
  +
*Link:[[File:BAT32G133GC.zip]]
*Link:
 

Revision as of 15:07, 14 November 2022

This article describes specifics for the CMSemicon BAT32G133-EVB evaluation board.

BAT32G133-EVB

PICTURE will follow

Minimum requirements

  • J-Link software V7.82c or later

Preparing for J-Link

  • Solder Header to the board (row on the side of the Chip)
Device Side J-Link Signal Pin
CLK SWCLK 9
DAT SWDIO 7
RST RESET 15
GND GND 4
VDD VTRef 1

You can use the following command line:

./JLink.exe -Device BAT32G133GC24SS -If SWD -Speed 4000 -autoconnect 1

In case of BAT32G157GK - for other devices adopt the -device setting.

The output should look as follows:
BAT32G133GC24SS connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard.
As the option bytes resides in the normal flash area it's not a good idea just to compile and flash.
Make sure that the option bytes are configured in a valid configuration.
In case of the example programs this has been done by modifying the Cortex_M_Startup.s with the following code:

  .section .vectors, "a"
  // fill to 0xC0 for the flash configuration field
  //.fill 0xC0-(_vectors_end-_vectors), 1, 0xFF
  .org 0xC0, 0xFF
  // 0xC0: WDT Control BYTE
  // 0xC1: LVD Control BYTE (C1H)
  // 0xC2: HOCO Control BYTE (FRQSEL)
  // 0xC3: Flash Protect Control BYTE
  // 0xC4: Boot Area Control BYTE
  // 0xC5: QSPI flash protect option BYTE
  // 0xC6: QSPI flash protect option BYTE0
  // 0xC7: QSPI flash protect option BYTE1
  OptBytes:
  .byte 0xEF, 0xFF, 0xF0, 0xFF, 0xFF, 0xFF, 0xFF, 0xFF

It is a simple Hello World sample linked into the internal flash.

SETUP

  • J-Link software: V7.82c
  • Embedded Studio: V6.40
  • Hardware: CMSemicon BAT32G133-EVB
  • Link:File:BAT32G133GC.zip