CMSemicon BAT32G133-EVB

From SEGGER Wiki
Revision as of 10:13, 14 November 2022 by Thomas.haase (talk | contribs) (Preparing for J-Link)
Jump to: navigation, search

This article describes specifics for the CMSemicon BAT32G1xxGx evaluation boards.

BAT32G133-EVB

PICTURE will follow

BAT32G157-EVB

PICTURE will follow

Minimum requirements

  • J-Link software V7.__b or later

Preparing for J-Link

  • Solder Header to the board (row on the side of the Chip)
Device Side J-Link Signal Pin
CLK SWCLK 9
DAT SWDIO 7
RST RESET 15
GND GND 4
VDD VTRef 1

You can use the following command line:

./JLink.exe -Device BAT32G157GK -If SWD -Speed 4000 -autoconnect 1

In case of BAT32G157GK - for other devices adopt the -device setting.

The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the .
It is a simple Hello World sample linked into the internal flash.

SETUP

  • J-Link software: V7.82b
  • Embedded Studio: V6.34
  • Hardware:
  • Link: