From SEGGER Wiki
Revision as of 14:52, 15 May 2024 by Simon Buchholz (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the ESWIN EMU32VL170 TEST BRD evaluation board.
ESWIN EMU32VL170 TEST BRD EMU32VL170 board.jpg

Preparing for J-Link

  • Connect the J-Link to J88.
  • Power the board via J91.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

ESWIN EMU32VL170 TEST BRD EMU32VL170 connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ESWIN EMU32VL170 TEST BRD.
It is a simple Hello World sample linked into the internal flash.