GigaDevice GD32A503-EVAL

From SEGGER Wiki
Revision as of 08:01, 9 November 2022 by Torben.scharping (talk | contribs) (Created page with "__TOC__ This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board. 450px == Minimum requirements == * J-Li...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board.

MM PLUS5270 MM32F5270 Board.jpg

Minimum requirements

  • J-Link software V6.83 or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (P15)
  • Power the board via external power supply / power jack (J4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MM PLUS5270 MM32F5270 Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.

SETUP