GigaDevice GD32A503-EVAL

From SEGGER Wiki
Revision as of 11:15, 9 November 2022 by Torben.scharping (talk | contribs)
Jump to: navigation, search

This article describes specifics for the GigaDevice GD32A503-EVAL evaluation board.

GD GD32A503V-EVAL Board.jpg

Minimum requirements

  • J-Link software V6.83 or later

Preparing for J-Link

  • Connect the J-Link to the JTAG header (JP2)
  • Power the board via USB (GD-LINK CN100)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

GD GD32A503 EVAL GD32A503VD Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion PLUS5270 MM32F5270.
It is a simple Hello World sample linked into the internal flash.

SETUP