Difference between revisions of "GigaDevice GD32E103C-START"

From SEGGER Wiki
Jump to: navigation, search
(Preparing for J-Link)
(Example Project)
 
Line 35: Line 35:
   
 
== Example Project==
 
== Example Project==
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E103C-START. It is a simple Hello World sample linked into the internal flash.
+
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E103C-START. It is a simple blinky application which toggles LED2. The application is linked into the internal flash.<br>
 
'''SETUP'''
 
'''SETUP'''
*J-Link software: V6.87a
+
*J-Link software: V6.87b
*Embedded Studio: V4.52b
+
*Embedded Studio: V4.52b (or later)
 
*Hardware: GigaDevice GD32E103C-START
 
*Hardware: GigaDevice GD32E103C-START
 
*Link: [[File:GigaDevice_GD32E1_TestProject_ES_V452b.zip]]
 
*Link: [[File:GigaDevice_GD32E1_TestProject_ES_V452b.zip]]

Latest revision as of 13:57, 29 September 2020

This article describes specifics for the GigaDevice GD32E103C-START evaluation board.

GigaDevice GD32E103C.jpg

Minimum requirements

  • J-Link software V6.87a or later

Preparing for J-Link

The GD32E103C-START does not come with a standard debug connector. Therefore, these signals have to be wired manually to connect the J-Link to the evaluation board. The following guide will describe how the GD32E103C-START evaluation board can be connected to your J-Link.

  • Populate the the pin headers JP5 and JP6
  • Connect the board with jumping wires to your J-Link (see table below)
    For information about the J-Link pinout please refer to the following page: J-Link SWD pinout.
J-Link 20 pin debug interface Pin on evaluation board
Pin 1 (VTref) +3V3
Pin 4 (GND) GND
Pin 7 (SWDIO) PA13
Pin 9 (SWCLK) PA14

The result should be looking like this:

GD32E103C-START wired with jumper cables

  • Power the board via the USB port (CN2).
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

GD32E103C-START Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32E103C-START. It is a simple blinky application which toggles LED2. The application is linked into the internal flash.
SETUP