GigaDevice GD32L233R-EVAL

From SEGGER Wiki
Revision as of 13:50, 28 June 2022 by Matthias (talk | contribs) (→‎Preparing for J-Link)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the GigaDevice GD32L233R-EVAL evaluation board.

GigaDevice GD32L233R-EVAL.jpg

Minimum requirements

  • J-Link software V7.67c or later

Preparing for J-Link

  • Connect the J-Link to the pins as seen in the image below:

GigaDevice GD32L233R-EVAL connected.jpg

  • Power the board via usb power supply
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

GigaDevice GD32L233R-EVAL Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the GigaDevice GD32L233R-EVAL. It is a simple Hello World sample linked into the internal flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=GigaDevice_GD32L233R-EVAL&oldid=12184"