HPMicro HPM6750EVKMINI

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the HPMicro HPM6750EVKMINI evaluation board.

HPMicro HPM6750EVKMINI.jpg

Minimum requirements

  • J-Link software V7.63c or later

Preparing for J-Link

To use HPM6750EVKMINI with an external J-Link some soldering is neccessary.

  1. Disconnect TCK and TRST to FT2232 by removing R45 and R49
    HPM6750EVKMINI R45 R49.png
  2. Connect TDO (T7), TDI (T8), TCK (T9), TMS (T10), and TRST (T11) to external debug probe.
    HPM6750EVKMINI TDO TDI TCK TMS TRST.png
  3. VTref and GND can be connected from R44(VTref) and R51(GND) respectively on the side facing the USB-C port.
    HPM6750EVKMINI VREF GND.png

After that, connect the board with the soldered on wires to your J-Link (see table below)
For information about the J-Link pinout please refer to the following page: J-Link JTAG pinout.

The result should be looking like this:

HPM6750EVKMINI wired

  • Power the board via the USB port (J3).
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

HPM6750EVKMINI Connect.PNG