Difference between revisions of "HSXP HK32F030M"

From SEGGER Wiki
Jump to: navigation, search
(Example Project)
(Preparing for J-Link)
Line 9: Line 9:
   
 
== Preparing for J-Link ==
 
== Preparing for J-Link ==
*Connect the J-Link to the SWD header (CN1) on the right side
+
*Connect the J-Link to the SWD header (CN1) on the right side with jumper cables.
 
*Power the board via the USB connector
 
*Power the board via the USB connector
   

Revision as of 09:27, 10 January 2022

This article describes specifics for the HSXP_HK32F030M/0301M evaluation board. It can be used to test & verify HK32F03xx series device support.

HSXP HK32F030M.jpg

Minimum requirements

  • J-Link software V7.60c or later

Preparing for J-Link

  • Connect the J-Link to the SWD header (CN1) on the right side with jumper cables.
  • Power the board via the USB connector

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the HSXP HK32F030M /HK32F0301M. It is a simple Hello World sample linked into the internal flash.

SETUP