IS2083 Getting Started
Contents
Setup
- Download and install Keil PK51 tools V9.59 Download
- Download the J-Link package: Download
- Go to Keil installation directory
<Screenshot Explorer> AG xxxxxxxxxxxxxxxxxx (pic)
- Replace the TOOLS.INI in the Keil directory with the one from the J-Link package
- Navigate to BIN\
<Screenshot Explorer> AG xxxxxxxxxxxxxxxxxx (pic)
- Copy the following files from the J-Link package to this directory:
- JLinkBT5511.dll
- JLinkARM.dll
Connect to J-Link
- Connect a J-Link BASE / PLUS to the PC (HW V10, see label on the back side)
- Wait until the green LED becomes steady and stops blinking
- Download the uVision test project: Download
- Open the uVision test project
- Go to the project options
- Verify that your options look like as follows:
AG xxxxxxxxxxxxxxxxxxxx <Pics>
- Connect your target HW to J-Link via 2-wire JTAG (VTref, GND, RESET, TCK, TDI) as follows:
- Wiring:
J301 pin | J-Link pin |
---|---|
1 | 15 (RESET) |
2 | 1 (VTref) |
3 | 4 (GND) |
4 | 5 (TDI) |
5 | 9 (TCK) |
- Start a debug session by clicking the <PiC> symbol (Ctrl + F5)
- 2-wire JTAG is the default selection for a J-Link BT5511 project
- You will be asked if you want to update the firmware of the connected J-Link. Select YES.
- Happy debugging!