Difference between revisions of "IndieSemi Realplum-EVK"

From SEGGER Wiki
Jump to: navigation, search
(→‎Preparing for J-Link)
(→‎Preparing for J-Link)
Line 12: Line 12:
 
*Make sure that you install the correct "Upgrade Board"
  
*Make sure that you install the correct "Upgrade Board"
 
*Connect the J-Link to the SWD header (P1)
  
*Connect the J-Link to the SWD header (P1)
  +
  +
FOTO
  +
 
*Power the board via external power supply / power jack (J4)
  
*Power the board via external power supply / power jack (J4)
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
  
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:

Revision as of 15:01, 19 August 2020

This article describes specifics for the IndieSemi Realplum EVK.

TBD NXP JN5189-DK006.jpg

Minimum requirements

  • J-Link software V6.84 or later

Preparing for J-Link

  • Make sure that you install the correct "Upgrade Board"
  • Connect the J-Link to the SWD header (P1)

FOTO

  • Power the board via external power supply / power jack (J4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

IndieSemi Realplum Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the IndieSemi Realplum. It is a simple Hello World sample linked into the internal flash. SETUP

Retrieved from "https://wiki.segger.com/index.php?title=IndieSemi_Realplum-EVK&oldid=8628"