Difference between revisions of "IndieSemi Realplum-EVK"
(→Preparing for J-Link) |
(→Preparing for J-Link) |
||
| Line 34: | Line 34: | ||
**GND DC to "J3 --> GND" |
**GND DC to "J3 --> GND" |
||
| − | The resulting connection will then look like this: |
+ | The resulting connection will then look like this:<br> |
[[File:IndieSemi_RealplumEVK_connected.png|450px]] |
[[File:IndieSemi_RealplumEVK_connected.png|450px]] |
||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:<br> |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:<br> |
||
Latest revision as of 16:42, 19 August 2020
This article describes specifics for the IndieSemi Realplum EVK.
Minimum requirements
- J-Link software V6.83d or later
Preparing for J-Link
The IndieSemi Realplum EVK does not come with a standard debug connector but populates the debug SWD signals on a 4 pin header (CON1). Therefore, it can be manually wired in case J-Link shall be connected to it. Apart from the debug signals, the board does not route Vdd (3.3V) to VTref by default which is required for the J-Link. The following guide will describe how the Realplum EVK can be connected to your J-Link Base V10 or higher. Other J-Links might work as well but wiring might be slightly different. All needed information can be found in the probe related documentation.
- Solder a two pin header to J8 (VDD3V3)
- Close the soldered header using a jumper
- Now connect the board with e.g. jumperwires to your J-Link probe.
- The following table shows how the Signals should be connected on both the board and J-Link side.
| J-Link 20 pin debug interface | Pin on eval board CON1 connector |
|---|---|
| Pin 1 (VTref) | Pin 1 (Vdd) |
| Pin 4 (GND) | Pin 4 (GND) |
| Pin 7 (SWDIO) | Pin 2 (SWD) |
| Pin 9 (SWCLK) | Pin 3 (SWC) |
- Connect an external DC power supply to the board as follows:
- +3V DC to "J2 --> VDD3V3"
- GND DC to "J3 --> GND"
The resulting connection will then look like this:
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the IndieSemi Realplum. It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: >= V6.83d
- Embedded Studio: >= V4.52b
- Hardware: IndieSemi Realplum EVK
- Link: File:IndieSemi Realplum TestProject ES V452b.zip
