IndieSemi Realplum-EVK

From SEGGER Wiki
Revision as of 14:56, 19 August 2020 by Erik (talk | contribs) (Created page with "__TOC__ This article describes specifics for the IndieSemi Realplum EVK. TBD 450px == Minimum requirements == *J-Link software V6.84 or later...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the IndieSemi Realplum EVK.

TBD NXP JN5189-DK006.jpg

Minimum requirements

  • J-Link software V6.84 or later

Preparing for J-Link

  • Make sure that you install the correct "Upgrade Board"
  • Connect the J-Link to the SWD header (P1)
  • Power the board via external power supply / power jack (J4)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP QN9090 Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash. SETUP

Retrieved from "https://wiki.segger.com/index.php?title=IndieSemi_Realplum-EVK&oldid=8623"