Difference between revisions of "J-Link Remote Server"
(→Usage with different clients) |
|||
| Line 4: | Line 4: | ||
The J-Link itself does not need to provide an Ethernet interface, USB is sufficient. |
The J-Link itself does not need to provide an Ethernet interface, USB is sufficient. |
||
| + | = Connecting to J-Link using J-Link Remote Server = |
||
| − | = Usage with different clients = |
||
| + | |||
| + | When connecting to J-Link - for example when using the [[J-Link_Commander | J-Link Commander]] - in most cases, a connect string can be entered.<br> |
||
| + | When connecting to a J-Link via TCP/IP, the following syntax applies: |
||
| + | |||
| + | '''Variant 1''': |
||
| + | IP tunnel:SN |
||
| + | |||
| + | This variant can be used in the default case: When connecting to the SEGGER default tunnel server (jlink.segger.com) where the serial number has been used to register a J-Link. |
||
| + | |||
| + | '''Variant 2''': |
||
| + | IP tunnel:<SN/Nickname>[:<Password>[:<TunnelServer>]] |
||
| + | |||
| + | {| |
||
| + | | <SN/Nickname> || Either the J-Link's serial number or [[J-Link:Nickname | Nickname]] |
||
| + | |- |
||
| + | | <Password> || Password that was used when setting up the Remote Server. If no password was used, this field should be empty. |
||
| + | |- |
||
| + | | <TunnelServer> || Address or hostname of the tunnel server. This is only needed if a tunnel server other than the SEGGER default tunnel server (jlink.segger.com) is used. |
||
| + | |} |
||
| + | |||
| + | |||
| + | |||
| + | == Usage with different clients == |
||
* [[Connect_to_remote_J-Link_via_J-Link_Tunnel_Server | Embedded Studio]] |
* [[Connect_to_remote_J-Link_via_J-Link_Tunnel_Server | Embedded Studio]] |
||
* [[IAR_EWARM#Connecting_to_J-Link_via_J-Link_Remote_Server | IAR ]] |
* [[IAR_EWARM#Connecting_to_J-Link_via_J-Link_Remote_Server | IAR ]] |
||
Revision as of 09:10, 19 September 2019
J-Link Remote Server is a utility (available as command line or GUI application) that makes a J-Link accessible via IP, be it in the local network or from anywhere on the world. The J-Link itself does not need to provide an Ethernet interface, USB is sufficient.
Connecting to J-Link using J-Link Remote Server
When connecting to J-Link - for example when using the J-Link Commander - in most cases, a connect string can be entered.
When connecting to a J-Link via TCP/IP, the following syntax applies:
Variant 1:
IP tunnel:SN
This variant can be used in the default case: When connecting to the SEGGER default tunnel server (jlink.segger.com) where the serial number has been used to register a J-Link.
Variant 2:
IP tunnel:<SN/Nickname>[:<Password>[:<TunnelServer>]]
| <SN/Nickname> | Either the J-Link's serial number or Nickname |
| <Password> | Password that was used when setting up the Remote Server. If no password was used, this field should be empty. |
| <TunnelServer> | Address or hostname of the tunnel server. This is only needed if a tunnel server other than the SEGGER default tunnel server (jlink.segger.com) is used. |
