Difference between revisions of "Mindmotion-MB-032"
(Created page with "__TOC__ This article describes specifics for the Mindmotion MB-036 evaluation board. 450px == Minimum requirements == * J-Link software V7.82d...") |
|||
| Line 1: | Line 1: | ||
__TOC__ |
__TOC__ |
||
| − | This article describes specifics for the Mindmotion MB- |
+ | This article describes specifics for the Mindmotion MB-032 evaluation board. |
| − | [[File:MM-MB- |
+ | [[File:MM-MB-032-board.jpg|450px]] |
== Minimum requirements == |
== Minimum requirements == |
||
| Line 13: | Line 13: | ||
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows: |
||
| − | [[File: |
+ | [[File:MM_xxx_Connect.png|400px]] |
== Example Project== |
== Example Project== |
||
Revision as of 12:36, 28 November 2022
This article describes specifics for the Mindmotion MB-032 evaluation board.
Minimum requirements
- J-Link software V7.82d or later
Preparing for J-Link
- Connect the J-Link to the SWD header (P15)#########################################
- Power the board via USB (CN3)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-036 MM32F3270##########################################.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-036
- Link: File:MM PLUS5270 MM32F5270 TestProject ES V634.zip
