Difference between revisions of "Mindmotion-MB-032"
| Line 16: | Line 16: | ||
== Example Project== |
== Example Project== |
||
| − | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB- |
+ | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-032 ##########################################. <br> |
It is a simple Hello World sample linked into the internal flash.<br> |
It is a simple Hello World sample linked into the internal flash.<br> |
||
====SETUP==== |
====SETUP==== |
||
*J-Link software: V7.82d |
*J-Link software: V7.82d |
||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
| − | *Hardware: Mindmotion MB- |
+ | *Hardware: Mindmotion MB-032 |
*Link: [[File:MM_xxx_TestProject_ES_V634.zip]] |
*Link: [[File:MM_xxx_TestProject_ES_V634.zip]] |
||
Revision as of 12:37, 28 November 2022
This article describes specifics for the Mindmotion MB-032 evaluation board.
Minimum requirements
- J-Link software V7.82d or later
Preparing for J-Link
- Connect the J-Link #########################################
- Power the board via USB (CN3)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-032 ##########################################.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82d
- Embedded Studio: V6.34
- Hardware: Mindmotion MB-032
- Link: File:MM xxx TestProject ES V634.zip
