Mindmotion-MB-036

This article describes specifics for the Mindmotion MB-036 evaluation board.

Minimum requirements

• J-Link software V7.82d or later

Preparing for J-Link

• Connect the J-Link to the SWD header (P15)#########################################
• Power the board via USB (CN3)
• Verify the Connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MB-036 MM32F3270##########################################.
It is a simple Hello World sample linked into the internal flash.

SETUP

• J-Link software: V7.82d
• Embedded Studio: V6.34
• Hardware: Mindmotion MB-036
• Link: File:MM PLUS5270 MM32F5270 TestProject ES V634.zip