Difference between revisions of "Mindmotion-MM32 LQFP48"

From SEGGER Wiki
Jump to: navigation, search
(Minimum requirements)
Line 13: Line 13:
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
 
* Verify the Connection with e.g. [https://wiki.segger.com/J-Link_cannot_connect_to_the_CPU#Verify_functionality_using_J-Link_Commander J-Link Commander]. The output should look as follows:
   
[[File:MM_xxx_Connect.png|400px]]
+
[[File:MM_MM32F0144C6P_EVAL_MM32LQFP48_Connect.png|400px]]
   
 
== Example Project==
 
== Example Project==

Revision as of 13:28, 9 December 2022

This article describes specifics for the Mindmotion MM32 LQFP48 evaluation board.

MM-MM32 LQFP48-board.jpg

Minimum requirements

  • J-Link software V7.82e or later

Preparing for J-Link

  • Connect the J-Link to J3
  • Power the board via USB (J2)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

MM MM32F0144C6P EVAL MM32LQFP48 Connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion MM32 LQFP48 ##########################################.
It is a simple Hello World sample linked into the internal flash.

SETUP