Difference between revisions of "Mindmotion-NANO-F0270"
| Line 22: | Line 22: | ||
*Embedded Studio: V6.34 |
*Embedded Studio: V6.34 |
||
*Hardware: Mindmotion NANO-F0270 |
*Hardware: Mindmotion NANO-F0270 |
||
| − | *Link: [[File: |
+ | *Link: [[File:MM32_NANAO-0270_MM32F0273D7P_TestProject_ES_V634.zip]] |
Latest revision as of 17:43, 9 December 2022
This article describes specifics for the Mindmotion NANO-F0270 evaluation board.
Minimum requirements
- J-Link software V7.82e or later
Preparing for J-Link
- Connect the J-Link to J4 (Pin 1 is not at the DOT on the PCB, rotate cable 180°)
- Power the board via USB (UART or USB port)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Mindmotion NANO-F0270 MM32F0273D7P.
It is a simple Hello World sample linked into the internal flash.
SETUP
- J-Link software: V7.82e
- Embedded Studio: V6.34
- Hardware: Mindmotion NANO-F0270
- Link: File:MM32 NANAO-0270 MM32F0273D7P TestProject ES V634.zip
