Difference between revisions of "NUCLEO-F070RB"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ == How to use external debug probe with Nucleo board == Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics...")
 
(How to use external debug probe with Nucleo board)
 
Line 1: Line 1:
 
__TOC__
 
__TOC__
   
== How to use external debug probe with Nucleo board ==
+
== How to use an external debug probe with Nucleo board ==
 
Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics to see if the debug signals are routed to the Extension Connectors. These can then be connected with e.g. jumper wires to the J-Link debug interface.
 
Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics to see if the debug signals are routed to the Extension Connectors. These can then be connected with e.g. jumper wires to the J-Link debug interface.
   

Latest revision as of 14:16, 7 February 2019

How to use an external debug probe with Nucleo board

Some ST Nucleo boards can be connected to an external debug probe like J-Link. To do this check the schematics to see if the debug signals are routed to the Extension Connectors. These can then be connected with e.g. jumper wires to the J-Link debug interface.

In case of the NUCLEO-F070RB the wiring is as follows:


Nucleo Pin (Connector/Pin) J-Link debug signal (Pin)
GND (CN7_8) GND (4)
+3V3 (CN7_16) VTref (1)
PA13 (CN7_13) SWDIO (7)
PA14 (CN7_15) SWCLK (9)
RESET (CN7_14) RESET (15)

To make sure the on board ST-Link does not interfere with your probe additionally disconnect the two jumpers on CN2.