Difference between revisions of "NXP JN5189-DK006"
(→Debugging in SEGGER Embedded Studio) |
|||
| Line 16: | Line 16: | ||
[[File:NXP_QN9090_Connect.PNG|400px]] |
[[File:NXP_QN9090_Connect.PNG|400px]] |
||
| + | == Example Project== |
||
| − | == Debugging in SEGGER Embedded Studio == |
||
| + | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash. |
||
| − | |||
| + | '''SETUP''' |
||
| − | === Example projects for SEGGER Embedded Studio=== |
||
| + | *J-Link software: V6.64 |
||
| − | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample and can be downloaded here: |
||
| + | *Embedded Studio: V4.52b |
||
| − | |||
| + | *Hardware: NXP JN5189-DK006 (QN9090 upgrade board) |
||
| − | [[Media: NXP_QN9090_TestProject_ES_V452b.zip | Hello World sample ]] |
||
| + | *Link: [[File:NXP_QN9090_TestProject_ES_V452b.zip]] |
||
Revision as of 11:33, 5 May 2020
This article describes specifics for the NXP JN5189-DK006 evaluation board.
Minimum requirements
- J-Link software V6.74 or later
Preparing for J-Link
- Make sure that you install the correct "Upgrade Board"
- Connect the J-Link to the SWD header (P1)
- Power the board via external power supply / power jack (J4)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash. SETUP
- J-Link software: V6.64
- Embedded Studio: V4.52b
- Hardware: NXP JN5189-DK006 (QN9090 upgrade board)
- Link: File:NXP QN9090 TestProject ES V452b.zip
