Difference between revisions of "NXP MIMXRT106A-ALEXA2"
(Created page with "__TOC__ This article describes specifics for the NXP MIMXRT106A-ALEXA2 IoT evaluation board. TBD 450px == Minimum requirements == * J-Link sof...") |
(→Example Project) |
||
(2 intermediate revisions by the same user not shown) | |||
Line 4: | Line 4: | ||
TBD |
TBD |
||
− | [[File:NXP_JN5189-DK006.jpg|450px]] |
+ | <!--[[File:NXP_JN5189-DK006.jpg|450px]]--> |
== Minimum requirements == |
== Minimum requirements == |
||
Line 15: | Line 15: | ||
TBD |
TBD |
||
− | [[File:NXP_QN9090_Connect.PNG|400px]] |
+ | <!--[[File:NXP_QN9090_Connect.PNG|400px]]--> |
== Example Project== |
== Example Project== |
||
+ | The application toggles the red LED on the NXP MIMXRT106A-ALEXA2 IoT evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone. |
||
− | The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP JN5189-DK006. It is a simple Hello World sample linked into the internal flash. |
||
'''SETUP''' |
'''SETUP''' |
||
− | *J-Link software: V6. |
+ | *J-Link software: V6.83c |
*Embedded Studio: V4.52b |
*Embedded Studio: V4.52b |
||
− | *Hardware: NXP |
+ | *Hardware: NXP MIMXRT106A-ALEXA2 IoT (QSPI enabled) |
− | *Link: [[File: |
+ | *Link: [[File:NXP_MIMXRT106A-ALEXA2_QSPI_TestProject_ES_V452b.zip]] |
Latest revision as of 11:02, 15 February 2022
This article describes specifics for the NXP MIMXRT106A-ALEXA2 IoT evaluation board.
TBD
Minimum requirements
- J-Link software V6.83c or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J6)
- Power the board via USB C cable (CON1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
TBD
Example Project
The application toggles the red LED on the NXP MIMXRT106A-ALEXA2 IoT evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone. SETUP
- J-Link software: V6.83c
- Embedded Studio: V4.52b
- Hardware: NXP MIMXRT106A-ALEXA2 IoT (QSPI enabled)
- Link: File:NXP MIMXRT106A-ALEXA2 QSPI TestProject ES V452b.zip