NXP MIMXRT106A-ALEXA2
This article describes specifics for the NXP MIMXRT106A-ALEXA2 IoT evaluation board.
Minimum requirements
- J-Link software V6.83c or later
Preparing for J-Link
- Connect the J-Link to the SWD header (J6)
- Power the board via USB C cable (CON1)
- Verify the Connection with e.g. J-Link Commander. The output should look as follows:
Example Project
SETUP
J-Link software: V6.82a Embedded Studio: V4.50 Hardware: NXP MIMXRT595-EVK (Rev C1) Link: File:NXP MIMXRT595-EVK-RevC1 QSPI ES.zip
The application toggles the red LED on the NXP MIMXRT106A-ALEXA2 IoT evaluation board. The application is linked into the external flash. It includes a valid boot header so it also runs stand-alone.
SETUP
- J-Link software: V6.83c
- Embedded Studio: V4.52b
- Hardware: NXP MIMXRT106A-ALEXA2 IoT (QSPI enabled)
- Link: File:NXP MIMXRT106A-ALEXA2 QSPI TestProject ES V452b.zip