NXP RD-RW616-BGA IPA-2A/1A

From SEGGER Wiki
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

This article describes specifics for the NXP RD-RW616-BGA_IPA-2A/1A evaluation board.
NXP RD-RW612-BGA RW612EV board.jpg

Preparing for J-Link

  • Power the board via J1
  • Jumper JP1 must be set in order to use J-Link

For use of SWD:

    • HD12 1-2 has to be closed (RF_CNTL_2/CON[11])
    • Connect JLINK to P2 (SWD)

For use of JTAG:

    • HD12 1-2 has to be open (RF_CNTL_2/CON[11])
    • Connect JLINK to J19 (JTAG)
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

NXP RD-RW612-BGA RW612EV connect.png

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP RD-RW616-BGA_IPA-2A/1A.
It is a simple Hello World sample linked into the internal flash.

SETUP