ONSemi RSL15-EVB

From SEGGER Wiki
Revision as of 14:31, 22 September 2022 by Leon (talk | contribs) (Created page with "__TOC__ This article describes specifics for the ONSemi RSL15-EVB. It can be used to test & verify RSL15 support. 450px == Minimum requirement...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article describes specifics for the ONSemi RSL15-EVB. It can be used to test & verify RSL15 support.

ONSemi RSL15-EVB.jpg

Minimum requirements

  • J-Link software V7.82 or later

Preparing for J-Link

Either the built-in J-Link OB or an external J-Link may be used to connect to the target device.

Using J-Link OB

  • Power the board via USB-C
  • Verify the connection with e.g. J-Link Commander. The output should look as follows:

ONSemi RSL15 Connect OB.PNG

Using external J-Link

  • Connect J-Link to the JTAG/SWD header (J3)
  • Power the board via USB-C
  • Verify the connection with e.g. J-Link Commander.
    • Now the J-Link OB and the external J-Link are connected to the host. Make sure to select the desired J-Link when prompted.
  • The output should look as follows:

ONSemi RSL15 Connect.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the ONSemi RSL15-EVB V1.1. It is a simple count loop sample linked into the internal flash.

SETUP