Difference between revisions of "RTT Ramcode Sample for Cortex-M0+ (Keil MDK)"

From SEGGER Wiki
Jump to: navigation, search
(Manual)
Line 17: Line 17:
 
= Manual =
 
= Manual =
 
*After downloading and unzipping the project, open it with Keil µVision V5.24.2.0 or later.
 
*After downloading and unzipping the project, open it with Keil µVision V5.24.2.0 or later.
  +
'Remark: When using another Cortex M0+ device with different RAM sections, adapt the RAM sections accordingly in the Keil project settings:
 
*Build(F7) the project and start debugging by clicking on the Debug button (Ctrl + F5)
 
*Build(F7) the project and start debugging by clicking on the Debug button (Ctrl + F5)
 
*Start RTT Viewer and connect with the following settings:
 
*Start RTT Viewer and connect with the following settings:

Revision as of 14:52, 8 May 2019

This article describes how to get started with RTT within RAM on a Cortex-M0+ device. This article assumes that there is already a basic knowledge about RTT in general (what is RTT, etc.). If this is not the case, we recommend to read RTT chapter in the J-Link User Manual (UM08001).

Minimum requirements

In order to use ETB trace on the ATMEL ATSAMD21 devices, the following minimum requirements have to be met:

  • J-Link software version V6.44g or later
  • µVision V5.24.2.0 or later (if the sample project from below shall be used)
  • J-Link Plus HW version V10.1 or later

Sample project

RTT Ramcode

The following sample project is designed to be used with J-Link and Keil MDK to demonstrate RTT. The project has been tested with the minimum requirements mentioned above and a SAMD21 XPlained Pro evalboard. The sample project comes with a pre-configured project for Keil MDK that runs out-of-the box.

CortexM0+_RAM_RTT_Sample.zip

Manual

  • After downloading and unzipping the project, open it with Keil µVision V5.24.2.0 or later.

'Remark: When using another Cortex M0+ device with different RAM sections, adapt the RAM sections accordingly in the Keil project settings:

  • Build(F7) the project and start debugging by clicking on the Debug button (Ctrl + F5)
  • Start RTT Viewer and connect with the following settings:
RTT Viewer Settings












  • Running the ramcode (F5) in Keil results in the following output in RTT viewer:

RTT Viewer output



























Tested Hardware

SAMD21 XPlained Pro