Difference between revisions of "Raspberry Pi Pico"
(Created page with " thumb | right | 500 px | Raspberry Pi Pico evaluation board (RP2040) The Raspberry Pi Pico is a Raspberry Pi RP2040 evaluation board. It is the...") |
(→Setting up with J-Link) |
||
| Line 28: | Line 28: | ||
| "DEBUG" 1 || 9 || SWCLK |
| "DEBUG" 1 || 9 || SWCLK |
||
|- |
|- |
||
| − | | "DEBUG" 2 || 4 || |
+ | | "DEBUG" 2 || 4 || GND |
|- |
|- |
||
| "DEBUG" 3 || 7 || SWDIO |
| "DEBUG" 3 || 7 || SWDIO |
||
Revision as of 15:16, 4 February 2021
File:RP RP2040 Pico
Raspberry Pi Pico evaluation board (RP2040)
The Raspberry Pi Pico is a Raspberry Pi RP2040 evaluation board. It is the first MCU evaluation board published by Raspberry Pi.
Features (selection)
- RP2040 MCU
- 2MB on board QSPI flash
- Micro USB-B 1.1
- Temperature sensor
- On board LED
- external debug connector pads
For further information pelase refer to the Rapberry Pi Pico web page
Setting up with J-Link
The Respberry Pi Pico evaluation board comes with an external SWD connector pads (from left to right: SWCLK, GRD, SWDIO). To set it up with J-Link, the following steps are required:
- Solder a 3-pin pin strip (or jumper wires) to the debug connector pads.
-
- Solder a pin Strip to the GPIO pads of the evaluation board or a jumper wire to Pad 36 (3V3(OUT))
-
- Connect the pins with the J-Link by using Juper wires as follows:
Pin RP Pico Pin J-Link Signal "DEBUG" 1 9 SWCLK "DEBUG" 2 4 GND "DEBUG" 3 7 SWDIO 36 1 VTref
