Raspberry Pi RP2040

From SEGGER Wiki
Revision as of 13:31, 30 June 2021 by Alex (talk | contribs) (J-Link Support)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

This article covers the Raspberry Pi RP2040 device, an arm Cortex-M0+ dualcore MCU with up to 133 MHz Clock. It is the first MCU designed and published by Raspberry Pi. The RP2040 is present on the Raspberry Pi Pico evaluation board.

Features (selection)

Stat Specification
Core Dualcore M0+
RAM 264kB SRAM
Internal flash No internal flash (ext. QSPI supported)
Pins (multifunc) 30 GPIOs
Pins (dedicated) 6 SPI IOs

For further information please refer to the Raspberry Pi Pico web page

J-Link Support

The Raspberry Pi RP2040 is fully supported by J-Link.

  • Support was implemented with J-Link Software Pack V6.96.
  • Only 1st debug session after power-cycle or reset pin toggle successfully connected.
    • Since J-Link software V7.50: Power-cycle of MCU after 1st debug session is no longer required.

Evaluation boards

There are multiple RP2040 evaluation boards. For all of the ones listed below, sample applications are available.

Sample projects

SEGGER Embedded Studio provides a RP2040 board support package for the RP2040 Pico. It is easily adjusted to all other available RP2040 boards, especially, as the QSPI pin-out is not modifiable. Additionally, the articles listed under Evaluation boards all provide sample applications.