Difference between revisions of "Renesas EK-RA6M5"

From SEGGER Wiki
Jump to: navigation, search
(Created page with "__TOC__ This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify Renesas RA6M5 support. =Minimum requirements= * J-Link...")
 
Line 1: Line 1:
 
__TOC__
 
__TOC__
 
This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify [[Renesas RA6M5]] support.
 
This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify [[Renesas RA6M5]] support.
  +
  +
[[File:EK_RA6M5.jpg|450px]]
   
 
=Minimum requirements=
 
=Minimum requirements=

Revision as of 09:28, 7 April 2021

This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify Renesas RA6M5 support.

EK RA6M5.jpg

Minimum requirements

  • J-Link software V7.00 or later

Preparing for J-Link

  • Attach the board over the debug USB-port to your PC (J10 - J-LinkOB). This will power the board as well.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

ek ra6m5 commander.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M5. It is a simple Hello World sample linked into the internal program flash.

SETUP