Renesas EK-RA6M5

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the Renesas EK-RA6M5 evaluation board. It can be used to test & verify Renesas RA6M5 support.

EK RA6M5.jpg

Minimum requirements

  • J-Link software V7.00 or later

Preparing for J-Link

  • Attach the board over the debug USB-port to your PC (J10 - J-Link OB). This will power the board as well.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

ek ra6m5 commander.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas EK-RA6M5. It is a simple Hello World sample linked into the internal program flash.

SETUP

Retrieved from "https://wiki.segger.com/index.php?title=Renesas_EK-RA6M5&oldid=9888"