Renesas FPB-RA4E1

From SEGGER Wiki
Jump to: navigation, search

This article describes specifics for the Renesas FPB-RA4E1 evaluation board. It can be used to test & verify Renesas RA4E1 support.

FPB RA4E1.jpg

Minimum requirements

  • J-Link software V7.58 or later

Preparing for J-Link

  • Attach the board over the debug USB-port to your PC (J9 - J-Link OB). This will power the board as well.
  • Verify the Connection with e.g. J-Link Commander. The output should look as follows:

fpb ra4e1 commander.PNG

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the Renesas FPB-RA4E1. It is a simple Hello World sample linked into the internal program flash.

SETUP